EUCHNER EKS FSA with Ethernet Interface - Manual (Page 15)

Manual EKS Electronic-Key Adapter Ethernet
4.4.3 DIP switch S3
Function S3.1 S3.2 S3.3 S3.4
Fixed IP address OFF OFF
Default IP address 192.168.1.1 ON OFF
Obtain IP address from DHCP server OFF ON
Obtain IP address from a SINUMERIK control system ON ON
Internal function, leave switch OFF OFF
Allow configuration via web browser OFF
= any switch position
Information!
The usage of the DIP switches to assign the IP address is described in the following in section 6.1.1.
4.5 LED indicator
The Electronic-Key adapter operating states are indicated using a 3-color LED on the front.
The illumination of the LED in any color indicates the presence of the operating voltage.
Color Operating state Description
Red
Electronic-Key
adapter power up
or fault
After the application of the power supply, the LED is constantly illuminated red during
power up. The completion of the process is indicated by a change in this state after
approx. 20 seconds. If the LED then flashes red quickly, it is an indication of a network
fault.
Green Ready Network connected.
Yellow
Electronic-Key
active
Network connected. Electronic-Key is in the Electronic-Key adapter.
Red/Green
Red/Yellow
Fault
LED flashing slowly red/green (without Electronic-Key) or red/yellow (with Electronic-
Key). Network was connected and a network fault then occurred.
Information!
LED indications optimized from date of manufacture July 2008.
100420-02-01/09 Subject to technical modifications Page 15/40