ETC Sensor+ Touring Rack CEM+ to CEM3 Retrofit - Manual (Page 14)

12 CEM3 Sensor Touring Rack Retrofit Manual
Backplane Settings
Upgrade kit backplanes ship from the factory with all DIP switches in the off (down) position.
You will have to set the DIP switches on the new backplane to match your rack. You will
also have to verify the termination switch settings.
a: Set both termination switches to “Off” (middle position).
b: Using a precision screwdriver, set the DIP switches to match your rack type
according to:
• number of dimmers (48 or 96)
• whether the rack has Advanced Features (AF)
Use the following chart to determine your required DIP switch settings:
“On” position = switch pushed to the top
DIP switch Number
Rack Model 1 2 3 4 5 6 7 8
SP48 On
SP48 AF On On
SP96
SP96 AF
On
“Double Small” 96
“Double Small” 96 AF
On
Set termination to “Off”
(middle position)
Set DIP switches