Configure the cem3, N o t e – ETC Sensor+ CE Rack (ESR+) CEM+ to CEM3 Retrofit User Manual

Page 16

CEM3 Sensor+ ESR+ Rack Retrofit Manual

source is not present.

Configure the CEM3

Step 1:

Configure the rack to reflect the dimmer module types installed. Verify that the

rack type is correct (CEM3 should have determined this from the DIP switch

settings - see

). Configuration of the CEM3 is done

using the front face panel interface. See the CEM3 Quick Guide that ships with

the CEM3 for more information.

Step 2:

Configure the data types that will be used (DMX and sACN) including the rack

patch.

This concludes the retrofit procedure.

N o t e :

When first booting, CEM3 may upload firmware into the AF2 cards. This may take

10 minutes or more and is normal for a firmware update.