Safety – ETC Source Four Revolution with Wybron User Manual
Page 7
Overview
3
Safety
The Source Four Revolution high performance automated ellipsoidal spotlight is intended
for professional use only. Read entire User Manual before using equipment.
Please note the following safety notices before use:
W A R N I N G :
Note the following safety warnings before use:
•
Do not mount the Source Four Revolution fixture on or near a flammable surface.
•
Use the fixture in dry locations only, where humidity does not exceed 90 percent (non-
condensing). Fixture is not intended for outdoor use.
•
Mount and support the fixture only by the primary suspension holes in the upper
enclosure.
•
Suspend the fixture from a suitable structure using a minimum of two hook clamps
secured with tightened steel bolts (12 mm (1/2") Ø), washers and locking nuts.
•
In addition to primary suspension, attach a safety cable (ETC Model 400SC or other
approved safety cable or device) to the handles of the fixture’s upper enclosure.
•
Always replace the lamp if it becomes damaged or thermally deformed.
•
Keep the luminaire at least 0.7m (28") away from anything it is illuminating. Objects lit
at this distance or greater will not exceed 90°C (194°F) temperature from projected
light.
•
Disconnect the unit from power before all cleaning and maintenance.
•
Maximum ambient temperature: Ta=45°C (113°F)
•
Maximum exterior surface temperature: T
m
ax=270°C (518°F)
•
External Temperature after 5 minutes of operation: 35°C (95°F)
•
External Temperature (steady state achieved): 270°C (518°F)
0.7m