N o t e – ETC Source Four Revolution with Wybron User Manual

Page 31

Routine Maintenance

Step 4:

While pulling the latch on the top of the cartridge forward, press the cartridge into

place. Ensure that the gel is positioned between the two tag sensor guides.

Step 5:

Release the spring-loaded latch. Ensure it slides back into the locked position

and that it protrudes through the accessory plate.

Step 6:

Secure the scroller cartridge with the two retainer knobs.

C A U T I O N :

The retainer knobs must be tightened to safely fasten the scroller cartridge to the

fixture before the Revolution fixture is put into operation.

Step 7:

Recalibrate the fixture after replacing the scroller cartridge.

N o t e :

The gel string must ride in the tag sensor; not behind or in front of the sensor. If the

scroller does not find the long tag during recalibration, it will stall after approximately 60

seconds.

Installing or removing beam containment devices and color frames:

Step 1:

Push the latch on top of the scroller cartridge toward the back of the fixture head

to clear the accessory slot on the front of the cartridge.

Step 2:

Insert or remove the beam containment device or color frame.

Step 3:

Release the spring-loaded latch and it will slide back into the locked position. If

the safety tether is present, attach it to the installed beam containment device.

Gel String

Tag Sensor

Latch