ETC Source Four XT HID Zoom User Manual - Manual (Page 7)

5
.
Step 8: Align the flat sides of the lamp base with the lamp retaining clips on both sides of the
socket.
Figure-3 Inserting the Lamp into the Lamp Housing.
Step 9: Push down on the lamp base until the lamp seats firmly.
When properly installed, the base of the lamp will be secured by the lamp retaining clips.
Step 10: Reinstall the lamp assembly by aligning the lamp cap with the fixture.
Ensure the wire is pushed aside and not touching the lamp.
Step 11: Tighten the screws in a zig-zag pattern.
C A U T I O N : Use caution when installing or replacing any lamp.
When installing or replacing lamp, be sure to point the lamp away from your face
and away from others before inserting it firmly into the assembly.
This may prevent injuries if the lamp should break.
N o t e : To avoid premature lamp failure, do not touch the lamp glass. If you do, clean it
carefully with isopropyl alcohol and a clean lint-free cloth. Allow to dry before
operation.
C A U T I O N : Improperly installed lamps cause premature lamp failure and socket problems.
INCORRECT
CORRECT
HID lamp
Lamp housing
Lamp retainer clips