Adding events from the show control display, N o t e – ETC Eos Family Show Control User Manual
Page 17
Time Code
15
When working in Live, to show the Time Code times in the Cue List, go to the Cue List
Display.
•
[Cue] [Cue]
Select the Cue List to be triggered.
•
[Cue] [1] [/]
Now associate the Event List to the Selected Cue List.
•
[Cue] [1] [/] {Execute} {Timecode} {1} [Enter]
Now in the cue display, for each cue, the execute column will display the time of the first event in
the Time Code list that triggers that cue.
To change the time that a cue will be triggered by time code.
•
[Cue] [1] {Execute} {TimeCode} [5][4][5] [Enter]
Changes the time of the first event that fires cue 1 to 5:45. If no event currently triggers cue
1, it will be created in the list.
•
[Cue] [1]{Execute} {TimeCode} [-][5] [Enter]
Subtracts 5 from the current time, [+] would add 5 to the current time.
Both the Event List and the Cue List are ready for events to be added. There are three ways that
events can be added into the Event List.
Adding Events from the Show Control Display
Events can be added directly from the show control display, however a new event number must be
specified for each event action.
Open the show control display.
•
[Displays]>
Select the event list.
•
Specify a new event number.
•
Add the action that the event should execute.
•
Define the time code position of the event.
•
It is possible to enter multiple commands in the same command line. This can speed up
your programming. For example:
N o t e :
You will notice as events are added in the Event List that the time code will display
on the Playback Status Display.
N o t e :
This is the same process for MIDI and SMPTE Time code.
N o t e :
As there is no action softkey, pressing [Cue], [Sub], or [Macro] assumes you are
posting to the action field.