ElmoMC SimplIQ Digital Servo Drives-Whi-Trio Installation Guide - Manual (Page 6)

Safety Information
In order to achieve the optimum, safe operation of the Trio, it is imperative that you
implement the safety procedures included in this installation guide. This information
is provided to protect you and to keep your work area safe when operating the Trio
and accompanying equipment.
Please read this chapter carefully before you begin the installation process.
Before you start, ensure that all system components are connected to earth ground.
Electrical safety is provided through a low-resistance earth connection.
Only qualified personnel may install, adjust, maintain and repair the servo drive.
A “qualified person” has the knowledge and authorization to perform tasks such as
transporting, assembling, installing, commissioning and operating motors.
The Trio contains electrostatic-sensitive components that can be damaged if handled
incorrectly. To prevent any electrostatic damage, avoid contact with highly insulating
materials, such as plastic film and synthetic fabrics. Place the product on a conductive
surface and ground yourself in order to discharge any possible static electricity build-
up.
To avoid any potential hazards that may cause severe personal injury or damage to
the product during operation, keep all covers and cabinet doors shut.
The following safety symbols are used in this manual:
Warning:
This information is needed to avoid a safety hazard, which might
cause bodily injury.
Caution:
This information is necessary for preventing damage to the product
or to other equipment.
Note:
This is auxiliary information that ensures the correct operation of
the equipment.