ElmoMC SimplIQ Digital Servo Drives-Whi-Trio Installation Guide - Manual (Page 40)

.16 Powering Up
After the cables have been connected to their devices, the Trio is ready to be powered up.
Caution:
1. Before applying power, ensure that the AC/DC supply are both isolated and
within the specified range.
2. When using a DC supply, ensure that the proper plus-minus connections are
in order.
.17 Initializing the System
After the Trio has been connected and mounted, the system must be set up and initialized.
This is accomplished using the Composer, Elmo’s Windows-based software application.
Install the application and then perform setup and initialization according to the directions
in the Composer Software Manual.