Elkhart Brass 70133000 Electric Valves - Manual (Page 23)

23
Output torque adjustment – closing direction of travel
Important: Refer to Actuator Default Settings above.
To modify the default setting, proceed as follows:
The setting are adjustable between 40% and 100% of the actuators rated torque output. Each adjustment step
using SW6 is equal to approximately 6.67% of actuators rated torque.
To adjust, proceed as follows:
- Enter setup mode: move switch SW3 to the ON position
- Rotate switch SW4 to position 6
- Rotate switch SW6 to: positions 0-9 to select the torque output required
- Push ENTER pushbutton SW5 to confirm
- When pushing SW5, the red LED will blink once to confirm that the setting is accepted
- Exit setup mode (move switch SW3 to position 1) or proceed to the next step
Output torque adjustment – opening direction of travel
Important: Refer to Actuator Default Settings above.
To modify the default setting, proceed as follows:
The setting are adjustable between 40% and 100% of the actuators rated torque output. Each adjustment step
using SW6 is equal to approximately 6.67% of actuators rated torque.
To adjust, proceed as follows:
- Enter setup mode: move switch SW3 to the ON position
- Rotate switch SW4 to position 7
- Rotate switch SW6 to: positions 0-9 to select the torque output required
- Push ENTER pushbutton SW5 to confirm
- When pushing SW5, the red LED will blink once to confirm that the setting is accepted
- Exit setup mode (move switch SW3 to position 1) or proceed to the next step
Output rotation selection (CW of CCW)
- Enter setup mode: move switch SW3 to the ON position
- Rotate switch SW4 to position 8
- Rotate switch SW6 to position 1 for counter-clockwise (CCW) operation. 0 for CCW OFF
- Push ENTER pushbutton SW5 to confirm
- When pushing SW5, the red LED will blink once to confirm that the setting is accepted
- Reverse mode (CCW) set is now completed
- Exit setup mode (move switch SW3 to position 1)