Elkhart Brass 70133000 Electric Valves - Manual (Page 14)

14
ELECTRICAL CONNECTIONS
Before applying power to the actuator, ensure that the supply voltage details on the nameplate are correct for
the installation. Access to terminals for electrical connections is through the terminal cover.
WARNING: After electrical installation, ensure that the removal of the cover assembly performed
per all applicable safety and environmental rules.
WARNING: All accessories (Cable Glands in particular) must be certified per the requirements of
the installation area and all relevant regulations.
WARNING: Actuator setup must be done while the actuator is energized. All setup operations
must be performed by qualified personnel.
Important: As the installed conditions are unknown to Tyco Valves & Controls, responsibility for
proper selection of protective devices must be the responsibility of others.
REMOVAL OF THE TERMINAL BOARD ENCLOSURE
Using a 5mm Allen wrench, loosen the four (4) screws and remove the cover. The screws are captive.
WARNING: Ensure that the edges of the cover or enclosure are not damaged during removal.