Elkhart Brass 70133000 Electric Valves - Manual (Page 22)

22
- Electrically operate the actuator in the open direction until the actuator stops
- Exit setup mode (move switch SW3 to position 1) or proceed to the next step:
Stroke time setting – closing direction of travel
Important: Refer to Actuator Default Settings above.
To modify the default setting, proceed as follows:
- Enter setup mode: move switch SW3 to the ON position
- Rotate switch SW4 to position 4
- Rotate switch SW6 to: positions 0-9. Choose the required stroke time from the STROKE TIME
SELECTION TABLE below.
- Confirm by pushing ENTER pushbutton SW5
- When pushing SW5, the red LED will blink once to confirm that the setting is accepted
- Exit setup mode (move switch SW3 to position 1) or proceed to the next step:
Model
Nominal
Torque
(Lbs-inches)
Operating Time (sec/90°) at selected step*
9 8 7 6 5 4 3 2 1 0
E6 600 12 15 18 26 38 48 60 75 85 110
E13 1300 12 15 18 26 38 48 60 75 85 110
E25 2500 12 15 18 26 38 48 60 75 85 110
E51 5100 12 15 18 26 38 48 60 75 85 110
E91 9100 20 24 30 45 60 80 100 120 140 180
E171 17100 44 53 66 100 132 180 220 264 310 400
*Times are +/- 10% tolerance for a 90° stroke.
Stroke time setting – opening direction of travel
Important: Refer to Actuator Default Settings above.
To modify the default setting, proceed as follows:
- Enter setup mode: move switch SW3 to the ON position
- Rotate switch SW4 to position 5
- Rotate switch SW6 to: positions 0-9. Choose the required stroke time from the STROKE TIME
SELECTION TABLE above.
- Confirm by pushing ENTER pushbutton SW5
- When pushing SW5, the red LED will blink once to confirm that the setting is accepted
- Exit setup mode (move switch SW3 to position 1) or proceed to the next step