Despatch Stackable LCC/LCD - Manual (Page 39)

Stackable LCC/LCD Oven Owner’s Manual O PERATION
Version 26 39
Copyright © 2010 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
DISCONNECT
SWITCH
POWER Switch
DOOR RELEASE
5.3. Operating Procedure
5.3.1. Start Oven
1. Turn the yellow/red
DISCONNECT SWITCH to ON.
2. Press the POWER to ON.
a. The DOOR RELEASE
pushbutton will
illuminate. This means
the door can be opened.
b. For Optional Beacon Light-equipped Units Only: The amber (center)
beacon light will illuminate, indicating that the oven is ready to receive work
to be processed.
3. To open the oven door, press DOOR RELEASE while simultaneously pressing on the
door. The oven door will unlatch and open.
4. The heater is wired in series with the door switch. The door must be completely
closed and locked to activate the heater.
5.3.2. Working with Protocol Plus Operating Modes
Refer to the Protocol Plus Controller Owner’s Manual for specific information for
working with the controller.
5.3.3. Sequence of Operation for Ovens Equipped with Optional Beacon
Light
1. After starting the oven (refer to Section 5.3.1), the Protocol Plus controller initializes.
a. The oven should be idle, empty, with the door closed and awaiting the next lot
for processing.
b. The Protocol Plus Controller should not be running a profile.
2. Open the oven door.

During the process cycle, DOOR
RELEASE will not be lit, meaning
that the oven door may not be
opened.
Figure 13. Power the Oven.