Dascom 2600 User Guide - Manual (Page 104)

Tally Dascom 2610
91
7.2.1 PJL commands
These PJL commands can be used with internal Ethernet interface as well as with external
TallyCom III Pocket interface.
This functionality may be activated via the parameter
Jobcntl in the Advanced Menu.
Sequence Brief description
"ESC"%-12345X@PJL Universal Exit Language (UEL)
commands
@PJL ECHO ECHO command
@PJL EOJ
@PJL EOJ NAME=
EOJ (End of Job) commands
@PJL INFO STATUS INFO (Information Request) command
@PJL INFO CONFIG INFO of the printer configuration
@PJL INFO VARIABLES INFO of variables which can be set by
SET
@PJL INFO MEMORY INFO about the memory of the printer
@PJL USTATUS DEVICE = ON
@PJL USTATUS DEVICE = OFF
@PJL USTATUS DEVICE =
VERBOSE
@PJL USTATUS JOB = ON
@PJL USTATUS JOB = OFF
@PJL USTATUS PAGE = ON
@PJL USTATUS PAGE = OFF
@PJL USTATUSOFF
USTATUS (unsolicited status)
commands
@PJL JOB NAME =
@PJL JOB FILE =
@PJL JOB START =
@PJL JOB END =
@PJL JOB COPY =
JOB (Start of Job) commands
@PJL ENTER LANGUAGE Exit PJL and start normal parser
@PJL INFO USTATUS List each type of unsolicited status
@PJL USTATUS TIMED Enables timed unsolicited status
7.2.2 Barcode
Even the standard version of your printer has the possibility of using up to 23 different
MTPL barcode types.
Barcode mode can be accessed within every emulation. The user can
decide whether barcode is activated permanently or activated depending
on the situation by means of an escape sequence.
The printer prints small barcode in 240 dpi and wider barcodes in 120 dpi.