Dascom T5040 User Guide User Manual
Page 71
User Guide
Menu
63
Protocol
Ready/Busy
*
Xon/Xoff
Selects the type of protocol, i.e. a certain set of
rules and procedures for ensuring error-free
data exchanges between computer and prin-
ter. Details of the available protocols can be
found in the section
CTS
Valid
*
Invalid
Sets the signal CTS (Clear To Send) on or off.
If Parallel is selected
Parallel Bidir
On
*
Off
Sets the bidirectional data transfer
(IEEE1284): if set to on ECP is supported, if off
Nibble mode only is supported.
If RS232_2 is selected
3)
Baud rate 2
4800
9600
19200
*
38400
Selects the data transmission rate (baud rate)
(baud = bit per second).
Data bits 2
7
8
*
Selects the number of data bits per data byte.
Stop bits 2
1
*
2
Selects if one or two stop bits are used per
data byte.
Parity 2
Even
Odd
None
*
The parity test for received data bytes can be
selected. None causes transmission in both
directions without parity bit. If Even or Odd is
selected, the bytes are checked to ensure they
have even or odd parity.
Protocol 2
Ready/Busy
*
Xon/Xoff
Selects the type of protocol, i.e. a certain set of
rules and procedures for ensuring error-free
data exchanges between computer and prin-
ter. Details of the available protocols can be
found in the section
CTS 2
Valid
*
Invalid
Sets the signal CTS (Clear To Send) on or off.
MENU
EMULATION
Emulation type
Epson
* (USER1)
IBM Proprinter XL
Olivetti
* (USER2)
IBM 4722
Selects the emulation for the printer. For fur-
ther details refer to chapter
T5023 Compatible
No
*
Yes
Selects if the printer is compatible to the T5023
printer or not.
1) Only in Epson and IBM emulation
2) Only if MSR-H is installed
3) Only for printer model with second serial interface
Parameter group
Parameter
Possible settings
Description