Menu handling, Key functions, User1 key – Dascom T5040 User Guide User Manual
Page 57: User2 key, For further details refer to the section, Menu, Handling, Menu common, Return to prev. layer
User Guide
Menu
49
Menu handling
Key functions
You can navigate in the current menu using the three keys of the con-
trol panel.
USER1 key
In menu mode the USER1 key has the following functions:
Press the USER1 key to return to the pre-
vious parameter group or parameter on the
same menu level.
The USER1 key is also used for changing pa-
rameter settings (see also
page 50).
If this key is pressed when the first parameter
group or parameter of the respective menu le-
vel is active, the following message appears on
the LCD display:
Pressing the USER1 key again will open the
last parameter group or parameter of the same
menu level.
By pressing the STOP/EJECT key you will
return to the previous menu layer (see also
USER2 key
In menu mode the USER2 key has the following functions:
Press the USER2 key to select the next
parameter group or parameter on the same
menu level.
The USER2 key is also used to change
parameter settings (see also
page 50).
If this key is pressed when the last parameter
group or parameter of the respective menu le-
vel is active, the following message appears on
the LCD display:
MENU
COMMON
SETUP
USER1 STOP
/EJECT
USER2
PAPER
Return to
Prev. Layer
SETUP
USER1 STOP
/EJECT
USER2
PAPER
MENU
COMMON
SETUP
PAPER
USER1 STOP
/EJECT
USER2