Setting parameters (principle) – Dascom T5040 User Guide User Manual
Page 59
User Guide
Menu
51
Setting parameters
(principle)
Before you begin setting the parameters, you should check which para-
meters your system requires. Furthermore it is recommended to print
out the status page which contains the actual valid parameter values
(see
The initial values, which are activated after switching on or after error
correction, are determined using the adjustable printer parameters. In
many cases these parameters are overwritten by means of a system ap-
plication.
Changed parameter settings are stored when the settings menu is exited
and retain their values when the printer is switched off.
Make sure that the printer is in menu mode (see section
Press the USER2 key to select next main menu or press the USER1
key to select a previous main menu.
Press the STOP/EJECT key to enter to the Parameter select mode.
The LCD displays the respective parameter and MENU.
Press the USER2 key to select a next parameter or press the USER1
key to select a previous parameter.
Press the STOP/EJECT key to enter the MENU setting mode.
SETUP
PAPER
USER1
USER2
STOP
/EJECT
SETUP
PAPER
USER1
USER2
STOP
/EJECT
SETUP
PAPER
USER1
USER2
STOP
/EJECT
SETUP
PAPER
USER1
USER2
STOP
/EJECT