Dascom T5040 User Guide - Manual (Page 70)

Menu User Guide
62
Paper ejection drop *
hold
Selects the paper position after paper ejection.
Message display Off *
On
Selects displaying messages on or off in Oli-
vetti, EPSON and IBM 4722 emulation.
NOTE: These messages will not be displayed
if IBM Proprinter XL is selected as Emulation
Type.
MSR-H Standard
2)
IBM * (Olivetti)
DIN/ISO * (Epson)
ANSI
Selects the MSR-H (magnetic stripe reader)
standards.
MSR-H Duplicate
2)
Off *
On
Selects if the MSR block will be duplicated or
not.
MENU
DATA CR Code CR=CR *
CR=CR+LF
Defines the action prompted by a carriage
return.
CR=CR: carriage return only
CR=CR+LF: carriage return and a line feed.
LF Code LF=LF *
LF=CR+LF
Defines the action prompted by a line feed.
LF=LF: line feed only
LF=CR+LF: carriage return and line feed.
Zero Normal *
Slashed
Selects if normal zero (0) or the slashed zero
(Ø) is printed.
MENU
INTERFACES
Menu, interfaces
Type RS232_1
Parallel
USB
RS232_2
3)
Selects the interface. Printer can be configured
either for serial, parallel or USB connection.
Two interfaces can be used at the same time,
one assigned to USER1 and one to USER2.
If RS232_1 is selected
Baud rate 4800
9600
*
19200
38400
Selects the data transmission rate (baud rate)
(baud = bit per second).
Data bits 7
8
*
Selects the number of data bits per data byte.
Stop bits 1 *
2
Selects if one or two stop bits are used per
data byte.
Parity Even
Odd
None
*
The parity test for received data bytes can be
selected. None causes transmission in both
directions without parity bit. If Even or Odd is
selected, the bytes are checked to ensure they
have even or odd parity.
1) Only in Epson and IBM emulation
2) Only if MSR-H is installed
3) Only for printer model with second serial interface
Parameter group Parameter Possible settings Description