Dakota Ultrasonics DFX-7 plus MANUAL2 - Manual (Page 34)

Dakota Ultrasonics
30
HOLDOFF 3: Provides the user with the ability to delay the starting point of Gate3, a
specific distance from the first detection point found inside of the boundaries of the
Gate 2 settings. If no detection is found, the Gate2 width value is used as a starting
value for Gate3. Refer to page 83 for further info.
THRESHOLD3: Enables the user to set the sensitivity level of Gate3. The amplitude
of the signal must reach or exceed the threshold level before a measurement is
detected. Refer to page 83 for further info.
3.9 SETUP – Menu
OPEN: Displays a list of factory and user defined setups currently stored in memory.
These setups can be recalled and used at any time. Refer to page 154 for further
info.
SAVE: Provides the user with the ability to save a custom setup that has been
modified or created by the user. Refer to page 156 for further info.
DELETE: Provides the user with the ability to delete specific setups previously save
in memory. Refer to page 160 for further info.
DEFAULT SETUP: Loads a basic default setup. Use only as a last resort when the
setups in the DFX-7 have been corrupted and a computer is not accessible. Refer to
page 161 for further info.
LANGUAGE: Provides the user the ability to select different languages for the DFX-
7
. Refer to page 163 for further info.
3.10 DATA – Menu
NEW: Allows the user the ability to create a new alpha numeric grid, or sequential
log file with auto identifiers. It is equipped with custom parameters, rows, and
columns depending on the user’s application reporting requirements. Refer to page
129 for further info.