BT 3000 Classic - Manual (Page 48)

Diverse 3000 ~ Edition 7 ~ 28th February ’01 ~ 3723
44
Please note
If you go out of range of a base
station for a long time while your
handset is switched ON, it may
take more than 20 minutes to ‘find’
the base station again when you
come back within range. However,
by simply switching the handset
OFF for a moment, and then ON
again, it will find the base station
within a few seconds.
The handset does not ring
The ringer volume may be set too
low, or switched off at the base
station. To adjust the ringer volume
at the handset, see page 30.
Handset beeps
Are the handset batteries low?
You will hear a beep every 30
seconds.
If the Base Station is flashing?
You will hear four short beeps
when you press the
PHONE
button. Check you are still in
range of your base station.
Buzzing noise on my
Radio/TV/Answering Machine/PC
Diverse is too close and is
causing interference. Move it
further away.
BT accepts no responsibility for
damage caused to your Diverse 3000
Classic Handset and Charger by the
use of non-approved batteries.
No display appears
Is the handset switched on?
The battery may be flat or dead.
Recharge or replace the battery.
No dial tone
Is the telephone line cord
plugged into the phone socket
and the base station?
If other handsets are registered
on the base, the outside line may
already be in use. Wait until the
call is finished and try again.
The base station is flashing or you
cannot link up with the base station
Is the handset registered with the
base station? To register the
handset, see page 10. Is the
power cable connected at the
base and the power switched on
at the wall socket?
If you press the PHONE button
whilst is flashing, you will hear
four short beeps from the handset.
Please note
If you are still experiencing
difficulty, please call the Diverse
Helpline on 08457 908070 .
Diverse 3000 H_set & Charger 22/3/01 1:55 pm Page 44