Control Company 5035 ADVANCED MEMORY TIMER - Manual (Page 2)

ADVANCED
MEMORY TIMER
INSTRUCTIONS
You may repeat this process as often as
needed. Note: If RESET is pressed when the
time is stopped, it clears the display and the
memory.
TIMEOUT
The timer may be stopped during any
running time by pressing the STOP button.
Timing may be resumed by pressing the
START button.
STOPWATCH TIMING, UP TIMING
If the timer is running, press STOP to stop the
timer. Press the RESET button to clear the
display to zero.
Press the START button to start timing. The
timer may be stopped by pressing the STOP
button and restarted by pressing the START
button (timeout function). When timing has
been completed and the timer has been
stopped, press the RESET button to clear
the display to zero.
TIME-OF-DAY CLOCK SETTING
Switch the TIMER/CLOCK slide switch to
CLOCK. The display will show a flashing
colon on it. Press and hold down the SET
button (this will be confirmed with a sound)
while simultaneously pressing the HR (hour),
MIN (minute), or SEC (second) button. The
SEC button will reset the second digits to
zero when in the 0 to 30 seconds range, and
in the 31 to 59 seconds range it will reset
seconds to zero and advance the minute
digit by one.
BATTERY
An incorrect display or no display indicates
that the battery should be replaced. Use a
coin to open the battery cover on the back
of the timer. Equivalent battery replacements
are: RAYOVAC, RW42, DURACELL D357,
and EVEREADY 357. Insert the battery with
the positive side facing you. Replace the
battery cover. Do not over tighten the battery
cover.