Condux APS75 Underground Pulling Trailer User Manual

Page 19

!CAUTION: Disposal of all drained system oils and fluids must be

in accordance with local regulations.

Fill the hydraulic oil using the filler spout designated on (Maintenance drawing,

item 1).

!CAUTION: Ensure that no foreign matter enters the system along

with the oil; if possible filter the oil with a 10 µm filter.

Replace the filter cartridge after 500 working hours and then, every 1500 hours

(or at least annually).

Check that the hydraulic oil filter lamp lights only during start-up. If lit and any

other time it indicates that the hydraulic oil filter needs replacing.

For further maintenance instructions on the hydraulic components (pumps and

motors) refer to the enclosed documentation.

E. REDUCTION UNIT MAINTENANCE

Change the oil of the bull-wheel reduction unit (Maintenance drawing, item 7)

after 100 working hours and, thereafter, every 2500 hours (or at least annually).

To drain the reduction unit use the plugs on the lower part of their housings.

!DANGER: Manufacturer recommends removing gearbox oil when

hot. Always use suitable safety gear (gloves, etc.).

!CAUTION: Disposal of all drained system oils and fluids must be

in accordance with local regulations.

Fill the oil into the reduction unit using the proper fill spout

!CAUTION: insure that no foreign matter enters the system along

with the oil.

For further maintenance instructions on the reduction gear, refer to the enclosed

documentation.

F. OIL MAINTENANCE

At least once a year, or as frequently as required, using compressed air, blow all

debris from the fins of the oil coolers.

!CAUTION: Personnel cleaning the oil coolers as per above

should wear all required personal protective gear, including a

respirator.

G. GREASING

Grease all points not automatically lubricated daily, these include: Take-up Reel

Bearings, Levelwind Shaft, Pawl, and any other rotating component

(Maintenance drawing, items 5 and 8).

Use CASTROL MOLUBALLOY 6040 NLGI 2 (ISO VG 150) grease or equivalent

from the enclosed “SUGGESTED LUBRICANTS” table.