CHAMPION DL2000 Manual - Manual (Page 14)

Title
Installation & Operation
Rev 1.02A
Page 14
Troubleshooting the 3 Door LiftModel
 Will Not Start
1. Check master switch on the control box to make sure that it is “ON”.
2. Check circuit breaker that services the dishwasher. Make sure it is “ON”.
3. After (ONLY after) checking steps 1 and 2, call the service technicians.
 Out of Chemical
Check backup supply of chemicals. REMEMBER! Red product label to red tube, blue product label to blue
tube, and clear/white product label to clear/white tube. Note that sometimes extra product is left in storage
area at the direction of the restaurant manager. Before calling service technicians, check with the manager
for backup supplies.
 Dishes/Glasses are Not Clean
1. Before you call service technician, check your temperature gauge on the machine. Check to insure water
temperature is at least 120
°
F. The 3Door dishwasher must have hot water delivered from the primary
heater at 120
°
to 140
°
F. If temperature is okay, then…
2. Check that your water softener contains salt and is operating properly. Your service agreement from
company calls for hot/soft water.
3. Check that dishes are racked properly. Check the screen and wash arm tips. If they are clear, call the
service technicians.
 Machine Will Not Hold Water
Check the drain actuator for a knife, spoon, fork or foreign material then remove.
 Water Running on the Floor
If water is overflowing, the scrap accumulator or the scrap drawer may need to be cleaned. If not, call your
plumber- the drain may be clogged.
 Water Will Not Drain From the Machine
Check the drain solenoid. Call the service technician.
 Water Coming Out of the Door
End plugs may be missing or lose. Check inside the scrap accumulator drawer. If the end plug came off
during operation, it will be inside the scrap trap tray. Simply replace. If end plug is lost, call your service
technician.
 Machine Will Not Shut Off
You can turn off the machine in an emergency by turning off the master switch located on the back of the
control box. After turning off the master switch, call service technician.
 Machine Will Not Fill
Check gate valve on the top of the machine. Make sure “handle” has been opened. If it is, call your service
technician.