Caron 6044 User Manual
Page 12
6024 & 6044 Series Operations Manual
Rev F 02/14/12
Page 12 of 56
SECTION 3 -- INSTALLATION
Unpacking
Your new unit has been thoroughly packaged to avoid shipping damage. However, the
unit should be fully inspected upon arrival before signing for receipt. If the package has
visual damage, notes should be made on the freight bill and signed by the delivery
company. In the event of concealed damage after the unit is uncrated, keep the carton
and packaging material. Call the shipping company within 7 days of receipt, request
inspection and retain a copy of the inspection report.
Caron provides full on-site installation services for all models. Our installation services
guarantees the proper set-up and startup of all equipment. Please contact the Service
Department at 740-373-6809 or
Choosing a Location
To ensure proper operation, the unit must be located on a firm level surface, capable of
supporting approximately 800 pounds. The unit should be located in an 18°C
– 25°C
ambient area and where there is no direct airflow from heating and cooling ducts as well
as out of direct sunlight. Allow four inches of clearance on all sides of the product to
allow for connections and airflow.
The unit requires a dedicated electrical connection, a quality water source, and a floor
drain. Choose a location where these facilities are or can be made available. If a water
source, or a drain is not available, contact CARON customer service and ask about our
CRYS102 product line or click this web link for information on the product:
Preliminary Cleaning
Your new incubator was thoroughly cleaned prior to leaving the factory. It is
recommended however, to disinfect all interior surfaces with a general purpose
laboratory cleaning agent prior to using the product. After cleaning, dry all interior
components with a sterile cloth as necessary.
This product weighs in excess of 500 pounds.
Ensure that sufficient resources are available to
safely move the product.