Barranca Diamond BD-2003E Pro Series Core Saw - Manual (Page 9)

9
BD-2003 CORE SAW SAFETY
MAINTENANCE SAFETY
• NEVER lubricate components or attempt service on a running machine.
• Keep the machinery in proper running condition. Clean the machine after each day’s use. Follow
instructions for changing accessories. Inspect tool periodically and, if damaged, have repaired by
authorized service facility.
ELECTRICAL SAFETY
SET UP & TRANSPORTATION SAFETY
• ALWAYS use caution and follow the instructions when lifting and transporting this machine.
• ALWAYS tie down the machine when transporting. DO NOT tow this machine behind a vehicle.
• NEVER transport with the blade mounted on the machine.
• Lift only from the lift bail.
• Make sure the OFF/ON power switch on the electric motor is always in the OFF position before
inserting the machine’s power plug into an AC receptacle.
• Operate electric motor only at the specified voltage indicated on the nameplate.
• ALWAYS make sure electric powered machines are plugged into a properly grounded circuit. DO
NOT replace the motor with any motor that does not have a special grounding connection.
• DO follow all electrical codes in your area. ALWAYS check for buried electrical cables before
sawing. If unsure, contact the local utilities.
• ALWAYS disconnect AC power plug from power source before moving or servicing the machine.
• NEVER disconnect any “emergency or safety devices.” These devices are intended for operator
safety. Disconnection of these devices can cause severe injury, bodily harm or even death!
Disconnection of any of these devices will void all warranties.
• Unauthorized equipment modifications will void all warranties. Manufacturer does not assume
responsibility for any accident due to equipment modifications.
• NEVER use accessories or attachments, which are not recommended by Barranca Diamond for
this equipment. Damage to the equipment and/or injury to user may result.
• Make sure power cords are the proper size and in good condition. DO NOT allow a
power cord to become damaged. NEVER allow the power cord to come into contact with water,
fluids, heat, oil or sharp edges. ALWAYS ensure that the electrical extension cord is not
trapped underneath the machine.