Barranca Diamond BD-2003E Pro Series Core Saw - Manual (Page 19)

19
1. Ensure the ON/OFF switch is in the OFF position.
2. Verify the Movable Cutting Table moves freely along the Guide Rails.
3. Inspect the Diamond Blade for damage, cracks and debonding; verify the blade is
correct for the material being cut.
4. Inspect the Pump Assembly for damage - ensure the cord is free of cracks or cuts.
5. Inspect the BD-2003E for damage - ensure all cords are free of cracks or cuts.
BD-2003 CORE SAW INSPECTION & SETUP
Inspect Blade for damage Inspect Pump for damage
PRE-START INSPECTION
Prior to beginning work, a pre-start inspection of the saw should be performed.
ASSEMBLY
(A )
Open the stand and place
it on flat surface.
If using the MK Diamond Stand, follow the following steps.
(B)
Set saw on stand as
shown.
(C)
Ensure pins are placed
through holes on frame.
NOTE: