Barranca Diamond BD-2003E Pro Series Core Saw - Manual (Page 20)

20
BD-2003 CORE SAW SETUP & ASSEMBLY
MOVABLE CUTTING TABLE INSTALLATION
(A)
While holding the front, position
movable Cutting Table roller wheels
above Guide Rails.
(B)
Seat movable Cutting Table roller
wheels on saw Guide Rails.
(C)
Verify movable Cutting Table is
seated correctly by moving table
back and forth.
CONNECTING THE WATER PUMP
CAUTION
NOTE: To prevent pump damage, the Water Pump must be disconnected if
cutting with a Dry Blade.
To prevent possibility of electrical shock, the BD-2003E must be de-energized
when connecting the water pump.
(A)
Connect the Cooling Transfer
Tube to the inlet connection of
the Blade Guard.
(B)
Connect the Water Pump power
cord to the receptacle found on
motor.
WATER PUMP PREPARATION
(A)
Install Water Pump Dis-
charge Fitting.
(B)
Press one end of the Cooling
Transfer Tube into the Water
Pump Discharge Fitting.
(C)
Slide Cooling Flow Adjusting
Clamp on to the Cooling Trans-
fer Tube.