Barranca Diamond BD-2003E Pro Series Core Saw - Manual (Page 23)

23
BD-2003 CORE SAW MAINTENANCE
(A)
Loosen Motor Strap
(D)
Install new belt
(G)
Check tension
(B)
Push Motor forward
(E)
Seat belt in pulley groove
(H)
Continue adjustments
(C)
Remove old belt
(F)
Tighten Motor Strap
(I)
Tighten Motor Bolts
4. Loosen the Motor Adjustment Strap using a 9/16 inch wrench. Rotate counter clockwise to loosen (A).
5. Push the Motor forward to loosen the belt (B).
6. Remove the old belt (C).
7. Install the new belt (C).
8. Verify the belt is seated in the groove of the pulley (D).
9. Tighten the Motor Adjustment Strap using a 9/16 inch wrench. Rotate clockwise to tighten belt and
remove slack (E).
10. Check the belt for proper tension (G).
11. Repeat steps 8 and 9 until proper belt tension is achieved (H).
12. Tighten the Motor Mounting Bolts using 1/2 inch wrench. Rotate clockwise to tighten (I).
BELT INSPECTION, ADJUSTMENT AND REPLACEMENT