Barranca Diamond BD-2003E Pro Series Core Saw - Manual (Page 14)

14
Most motor problems are caused by improper
voltage and extension cords. Cord should be
one-piece and short as possible. Cord
selection should match the following table.
1-2 H.P.
25’
50’
75’
100’
150’
250’
Max. Cord Length
Max. Cord Length
Max. Cord Length
No. 12 Wire
No. 10 Wire
No. 8 Wire
115v 230v
NOTICE !
The BD-2003E is equipped with a number of safety decals (Figure 5) provided for operator safety and
maintenance information. Should any of these decals become unreadable, replacements can be ob-
tained by calling (800) 630-7682.
BD-2003E Safety Decal Sheet, Part No. 166011
OPERATION & SAFETY DECALS
BD-2003 CORE SAW SAFETY
Decal D Decal E
Decal C
Decal F
Decal A Decal B
Decal G
SERVICE OR
WARRANTY
FOR INFORMATION ON
PLEASE CALL
1-800-474-5594
CAUTION
DO NOT lift
blade guard
when engine
is running.
! WARNING
In the event of
blade failure,
replace blade
guard
immediately.
!
DO NOT operate this
equipment before
reading the owner’s
manual!
WARNING !
WARNING
Masonry, concrete, metal and other materials with silica in their composition
may give off dust or mists containing crystalline silica. Silica is a basic
component of sand, quartz, brick clay, granite and numerous other minerals
and rocks. Repeated and/or substantial inhalation of airborne crystalline silica
can cause serious or fatal respiratory diseases, including silicosis. In addition,
California and some other authorities have listed respirable crystalline silica as
a substance known to cause cancer.
!
CAUTION
DO NOT
operate without
guards in place.
!