Atop Technology AW5500C User manual - Manual (Page 85)

Atop Industrial Wireless Access Point
AW5500C
User Manual V. 1.0
80
6.4 AP Client Setup
If AW5500C is being added to a wireless network where Access Points (AP1) from other
vendors already existed, AW5500C could be set to AP Client mode to connect to that AP1 and
bridge the Ethernet clients to AP1. This setup is similar to Scenario #2, except that WDS is not
used. This is because WDS from different vendors might not be compatible.
Figure 6.4
For more information on how to configure your AW5500C for this topology, please refer to AP
Client Mode .
Note: wireless coverage is dependent on the environment.