3 ap client mode, Ap client mode – Atop Technology AW5500C User manual User Manual
Page 80
Atop Industrial Wireless Access Point
AW5500C
User Manual V. 1.0
75
5.3 AP Client Mode
This mode allows your AW5500C to connect to an AP. Ethernet clients connected to AW5500C
over the Ethernet
interface are allowed to access the network through AW5500C’s wireless
interface. Under this mode, the device uses its second MAC address as its wireless interface
instead of the first one.
Figure 5.6
Remember that your AW5500C can function as both a Regular AP and as an AP Client (the
latter connected to the first one).
Supposing we already have the network physically installed, the steps for configuring your
AW5500C as an AP Client are as follows.
On Operation Mode choose AP Client.
Click on
“Save Settings”, go then to Mobile Station under the Wireless section and
click on
“Scan network” to choose an SSID.
A window/tab will pop out; in that new window/tab, there will be the names of the
surrounding Wireless Networks. Choose the one that you already designated as your
Regular AP by selecting its corresponding SSID.
Click
“Connect”, this will make you close the pop-out window/tab, and leave you with