AMMCO 2800, 2801 Environmental Lathe-Enclosure - Manual (Page 9)

Important: Always read and follow operating instructions. • 7
Assembling Shield – 2801 and 2802
1. Position the SHIELD TOP and SHIELD SIDE (RIGHT
HAND AND LEFT HAND) assembly, as shown in fig. 9.
Figure 9 - Shield Assembly
2. Place 1/4-20 SCREWS through the SHIELD TOP
and SHIELD SIDE assembly and the plastic base from
the front side. Attach WASHERS and NUTS from the
rear of the unit and tighten.
3. Place a 10-24 x 1/2 PHILLIPS PAN HD. SCREW
through the top side of the SHIELD HINGE and through
the corresponding hole in the plastic CHIP SHIELD.
4. Position the SHIELD SUPPORT so that its beveled
corners are facing the beveled corners on the mating
SHIELD STOP.
Figure 10- Plastic Shield Assembly
5. Attach NUT to SCREW. Assemble the remaining
five SCREWS and NUTS before tightening any of them.
6. Attach electrical box assembly to the back of the
Enclosure using two 1/4” BOLTS, WASHERS and NUTS.
Electrical Wiring — 2801 Only
1. Remove the cover on the round box by taking out
the four screws.
Figure 11 - Electrical Box
2. Insert the emergency stop switch cable through
the empty box connector until the outside jacket just
enters the round box, or is completely inside the con-
nector. Tighten the two connector screws.
3. Loosen the two screws that are clamping the foot
switch cable enough to push the hood switch cable into
the box. Tighten the two connector screws.
4. Remove the yellow wire nut from the BLACK wire
of the foot switch and add the BLACK wire from the
hood switch. Screw connector on tightly.
5. Join the WHITE wires from all three switches
together with a yellow wire nut.
6. Connect the BLACK wire from the STOP SWITCH
to the jumper wire from the outlet using a yellow wire
nut.
7. Re-attach the round cover plate and gasket to the
box with the four screws. Refer to Wiring Schematic —
2801 on page 16.
3 Holes In Top Shield
Lower Strut
Bracket
4 Holes
In Shield
Bracket
10-24 x 1/2 Phillips Pan
Hd. Screw
Shield Stop
Shield Hinge
Shield
Support
10-24 Lock
Nut, ESNA
Chip Shield
Hood Switch
Cable
Box
Mounting
Tab
Emergency Stop
Switch Cable
Box Mounting
Tab