AMMCO 2800, 2801 Environmental Lathe-Enclosure - Manual (Page 8)

6 • Important: Always read and follow operating instructions.
26. Install INNER and OUTER SPACER BRACKETS
in their appropriate location between the bench and
the vertical brackets with the short bracket side of the
spacer next to the bench and the long bracket extend-
ing upwards (fig. 5). Use 8 ? BOLTS and ? NUTS. Hand
tighten the fasteners at this time.
Figure 5 – Completed Bracket Assembly
27. The top cover must mate properly with the lower
portion of the Enclosure when closed. If they do not,
shimming or adjusting the brackets of the rear support
structure is required.
28. Raise the top cover and measure the distance
from the floor to the front lip of the lower portion of the
Enclosure. Measure in multiple locations.
The measurement should not vary more than 1/4”
across the front of the Enclosure (fig. 6). If it does vary
by more than 1/4”, shim the structure until the measure-
ments are satisfactory.
Figure 6 – Measure In Multiple Locations
29. Install alignment SHIMS at the fasteners between
the SPACER BRACKETS and the VERTICAL MOUNTING
BRACKETS as necessary to achieve satisfactory mea-
surements across the front.
The Enclosure may also be shifted within the toler-
ances allowed by the lathe mounting bolts to fine tune
the adjustment.
30. When the front of the Enclosure is level within
1/4” and the top cover mates properly to the lower
portion, tighten all fasteners securely.
31. Check the fit of the top cover to the lower portion
again after tightening, and readjust as required.
32. Attach the 2” CHIP TUBE to the fitting under the
Enclosure chip tray with the HOSE CLAMP (fig. 7).
Figure 7 – Chip Tube And Chip Bucket
33. Slip the other end of the tube into the hole in
the top of the CHIP BUCKET and move the bucket into
place under the chip tray.
34. Route the lathe power cord through the hole
in the back of the Enclosure and plug it into a suitable
power source.
35. Plug the Enclosure power cord into suitable
power source.
36. Fasten the HANDLE and PULL STRAP to the
hood using two 5/16-18 x 1 1/4 SCREWS, two 5/16 ID
WASHERS and two 5/16 LOCK NUTS.
After placing the screws through the HANDLE and
the plastic, slide the PULL STRAP over the right-hand
screw. Then slide washers over both screws and secure
with the nuts.
Figure 8 - Handle And Pull Strap Assembly
Hose Clamp
Chip Tray
Chip Tube
Chip
Bucket
Pull Strap
5/16 ID
Washer
Hood
5/16 Lock Nut
Handle
5/16-18 x 1 1/4
Screw