AMMCO 2800, 2801 Environmental Lathe-Enclosure - Manual (Page 11)

Important: Always read and follow operating instructions. • 9
Operation
Operation — 2800 Only
1. Plug the fan cord into a 115V wall receptacle when
lathe is in use.
Operation — 2801 Only
Important: Do not plug fan or lathe into a wall power
source. Fan and lathe power cords must be plugged
into the Enclosure electrical receptacle or the safety
features will not function.
1. Plug the fan cord into the Enclosure receptacle.
2. Plug the lathe cord into the Enclosure receptacle.
3. Plug the ELE power cord into an approved power
source.
4. Push the lathe power switch to the ON position.
5. Lower shield.
6. Lower hood and pull the emergency switch out.
Lathe will come ON.
7. Push stop switch in and the lathe will shut off.
Note: Lathe will only run under one of these condi-
tions:
(1.) Hood is fully lowered.
(2.) Foot pedal is depressed–use only for setting up
tool bit depth of cut prior to lowering hood.
Operation — 2802 Only
CAUTION
Depressing the footswitch will start the
brake lathe WITHOUT the shields and guards
in place so that the set-up of the brake lathe
tooling can be accomplished. Keep fingers
out of the rotating workpiece hazard areas.
NOTICE: This AMMCO Model 2802 Brake Lathe
Enclosure complies with the CSA Z432-04 Safeguarding
of Machinery Standards (Reaffirmed 2009 edition). The
enclosed installation and operation instructions must
be followed. Refer to the instruction manual that was
provided with the brake lathe that is to be installed in
this Enclosure. Read the Hazards in this manual and in
the brake lathe manual before installing and operating
the brake lathe. There are Hazardous areas that must
be protected for your safety. DO NOT operate the
brake lathe or the Enclosure if any of the safety devices
are not in working condition. Correct any issues with
replacement parts only from AMMCO to insure that the
parts comply with the requirements of CSA Z432-04
Safeguarding of Machinery Standard.
Important: Do not plug fan or lathe into a wall power
source. Fan and lathe power cords must be plugged
into the Enclosure electrical receptacle or the safety
features will not function.
1. Plug the fan cord into the Enclosure receptacle.
2. Plug the lathe cord into the Enclosure receptacle.
3. Plug the ELE power cord into an approved power
source.
4. Push the lathe power switch to the ON position.
Note: The lathe can be stopped at any time by lifting
the hood, pressing the red emergency STOP button, by
pressing the STOP button on the outside (right-hand-
located switch), or by moving the lathe toggle switch to
the OFF position. If lathe is stopped at any time, it can
only be restarted by lowering the hood and pressing
the ON button switch at the right end of the Enclosure.
5. Install brake drum or rotor, and necessary silencer(s).
6. With CHIP SHIELD in place, safety glasses on, and
hands out of the way of the work-piece, the foot pedal
can be pressed to turn the lathe on. Set the tool(s) as
required for proper cut and remove your foot from the
pedal to stop the lathe.
7. Lower the Enclosure hood.
8. Insure that no bystanders are in front of the Enclo-
sure.
9. Proceed to the right side of the Enclosure and
press the START button to turn the lathe on and start
the cut process.
10. When the cut is complete, the lathe can be
stopped by lifting the Enclosure hood.