AMMCO 2800, 2801 Environmental Lathe-Enclosure - Manual (Page 12)

10 • Important: Always read and follow operating instructions.
Maintenance
1. Check the air filter regularly for contamination. The
replacement interval for the filter is directly proportional
to use. Replace the filter when the air flow is dimin-
ished.
The filter is the same air filter typically used in GM
passenger cars with the 454 cubic inch gasoline engine.
Seal the used filter in a plastic bag before disposal.
2.
Check the CHIP TUBE periodically to make sure it
is securely attached to the chip tray. Inspect the tube
for holes or cracks. Replace the tube if it is damaged
or leaks.
The CHIP TUBE is a typical 2” pre-heater hose.
3.
If the gas struts are damaged, or begin to weaken,
replace them with struts of the same force and length
as the originals. Failure to use the correct strut may
create a hazard to the operator. Replacement struts are
available from AMMCO.
4. Check the CHIP BUCKET and empty it before it
reaches capacity. If the CHIP BUCKET becomes full,
chips and other material will back up into the chip tray
and the interior of the Enclosure. Dispose of the mate-
rial in the bucket properly.
Electrical Source
115V, 60 Hz, 1 PH, Fused @ 20 A