AMMCO 2800, 2801 Environmental Lathe-Enclosure - Manual (Page 10)

8 • Important: Always read and follow operating instructions.
Additional Installation — 2802 Only
1. Remove the four screws holding the control box
cover on and lay the cover and screws to the side. Posi-
tion the box on the back of the Enclosure as shown in
(fig. 12), with the holes in the control box in line with the
holes in the Enclosure. Use the 1/4 SCREWS, NUTS,
and WASHERS provided to attach the control box.
Figure 12 - Position Control Box Onto Enclosure
2. Remove the cover from the START/STOP PUSH-
BUTTON SWITCH. Position the switch as shown in
figure 13 and attach the switch with #10 SCREWS,
WASHERS, and NUTS. Reinstall the cover.
Figure 13 - Fasten Switch On Enclosure
3. Insert the emergency stop switch cable through
the right hand of the control box until the outside jacket
is inside the box.
4. Wire the emergency stop switch, to the control
box as shown in the wiring schematic and figure 14.
Tighten cable connector screws.
Figure 14 - Control Box Wiring
5. Attach the HOOD SWITCH and HOOD SWITCH
MAGNET assemblies to the Enclosure using the #10
HARDWARE as shown in figure 15.
Figure 15 - Attach Hood Switch To Enclosure
6. Use the provided cable ties and attachment pads to
fasten the wires to the wires to the Enclosure.
7. Replace the control box cover and tighten the four
screws.
White
Black