Allen&Heath Xone DX - Manual (Page 34)

Allen & Heath User Guide for XONE:DX with Serato ITCH 1.7 34
EFFECTS TYPES EFFECT TYPES
TREMOLO
The Tremolo modulates the signal volume, lowering and increasing it rhythmically to the set time divi-
sions, as if you were performing a series of cuts on the mixer’s cross fader. The TIME knob determines
the rate of the volume drop, while the FEEDBACK knob modifies the modulation on the signal volume.
The depth of the cut is determined by the WET/DRY amount, with 100% being a cut to silence.
BITCRUSHER
Bitcrusher adds distortion and lowers the bit rate resolution of the audio source. This effect can either
sound glitchy or overdriven depending on what point your feedback or bit depth is set to.
REPEATER
This effect repeats audio chunks similar to a loop roll function. You can control Repeater mix depth, the
‘chance’ the playing audio stream will be repeated, the count at which the audio section will be repeated
for, and the time of the audio division to be repeated.
REVERSER
This effect reverses a section of the audio signal, mixing it with the original audio. You can control the
depth of the effect mix, the length of the audio stream to be reversed, and the probability of repeating
audio.
BREAKER
The breaker acts like a classic turntable styled 'stop' breaking function, where the audio winds down to a
complete stop before resuming playback once again. Depending on the length of the time set this effect
can sound like a quick fire stop button break all the way through to the classic "turning the turntable off"
technique, allowing the audio to slow down to a complete stop.