Allen&Heath Xone 3D User Manual
Page 14
Allen & Heath
14
XONE:3D User Guide
+ 6
OFF
+ 10!
1
FILTER
1
CUE
2
OFF
HF
OFF
LF
+ 6
OFF
MF
+ 6
LEVEL
-10
+ 10
0
FX2
0
+ 6
0
FX1
0
+ 6
PRE
-15
-20
OO
-6
-3
-10
+ 3
+ 6
0
XFADE
X
Y
SC 1 - 2
LINE B
LINE A
MIXER SECTION — CHANNEL INPUT
1
2
3
4
FX 1-2 send controls
These controls adjust the signal level that
is sent from each channel to the two FX
mix busses. These signals will appear at
the RCA sockets on the rear of the unit.
FX1 PRE switch determines whether the
FX1 send signal is affected by the channel
fader. When pressed the signal is pre-
fader, when released post-fader.
FX1 can also be sent to the input of the
soundcard for processing or recording by
the PC (see Soundcard Mode for details).
FX2 is pre-fader (this can be changed
internally - see User Options). FX2 can
also be selected as the audio source for
the Auto Beat detector (See BPM
Detector).
1
Input Selection
Two switches select one of three possible
stereo audio sources; Line A (RIAA phono
on CH 2–4), Line B, or output from the
computer via the internal soundcard (SC1-
6). Switch 2 (SC) overrides switch 1
(phono/line). The led indicator displays
which source is active:
CH1 CH2 CH3 CH4
Switch1 gn
LineA Phono Phono Phono
Switch1 red LineB LineB LineB LineB
Switch2 red SC1-2 SC3-4 SC5-6 SC1-2
2
Channel Level Control
This control has a range of +/- 10dB either
side of the 0dB centre position. Use it to
adjust the signal level of an audio source to
give a nominal 0dB reading on the channel
meter, with the peak level at or below
+6dB. Turn LEVEL down if the +10 peak
meter starts flashing.
3
Channel Equalizer/Isolator
The Xone:3D is equipped with a very
powerful 3 band EQ stage providing a
controlled +6dB of boost when fully
clockwise, but full isolation (cut) of each
band for dramatic effect when fully anti-
clockwise. Centre frequencies are set at:
HF = 10kHz (high frequency, treble)
MF = 1.2kHz (mid frequency)
LF = 120Hz (low frequency, bass)
4