AiM MyChron4 660 - Manual (Page 29)

MyChron4 660
User Manual
Release 1.03
www.aim-sportline.com 28
In the second part on top right the test number is indicated:
Right below, in the third section, you see the labels referred to
the values contained in the next section: Maximum RPM,
Shaft, EGT(Exhausted Gas Thermocouple), and CHT
(Cylinder Head Thermocouple) value, Over drive
1:1(intersection point between RPM and Shaft), Overdrive
(difference percentage between RPM and Shaft), Staging
RPM (average RPM values in the 7/10 before the starting).
In the fifth section you find the time when the correspondent
value has been recorded.
To change the test number press <<” and “>>” buttons.