2N VoiceBlue Next v3.1 - Manual (Page 50)

50
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Caution
The BTS lock service works with specific GSM modules only
(Q55)!
An error in BTS identification results in a GSM module login
failure.
After call relax delay – interval between the current call termination and next call
setup via the same GSM/UMTS module. 2 seconds is recommended for
high–traffic installations.
Disconnect call
Specify the reasons for an immediate disconnection of an outgoing GSM/UMTS call.
Send CLIP from VoIP to GSM/UMTS
Transfer CLIP to GSM/UMTS – enable/disable the function.
Separating char – the CDN / CLIP separating character.
Modify (" removes one digit) – you can change the CLIP. The "– character is used
for deleting one char from the left.
Caution
The service must be supported Send CLIP from VoIP to GSM
by the GSM/UMTS provider. If not, the provider's network may
reject the call!
Basic settings
Roaming enabled for network code – set the international network identifier for
roaming purposes consisting of the following two codes:
MCC – Mobile Country Code – country code (Czech Republic – 230);
MNC – Mobile Network Code – GSM code (T–Mobile – 01, 0202, Vodafone –
03).
Hence, the international identification code for T–Mobile CZ is 23001. Leave this field
empty to disable roaming.
String Note
Roaming is disabled
2300 Roaming is disabled (5 digits is the minimum count)
23002 Roaming is enabled for networks with MCC+MNC code 23002
230XX Roaming is enabled for networks with MCC+MNC codes 23000 – 23099
XX001 Roaming is enabled for networks with MCC+MNC codes 00001 – 99001
XXXXX Roaming is enabled for any network
Note
Check the GSM/UMTS searching priorities on the SIM card using
your mobile phone before enabling roaming.