2N Omega Lite - Configuration Tool manual v1.7 User Manual
Page 108
108
2.15.7. MANUAL CONNECTION
Setting of PBX To Be Supervised
Manual connection is used if :
1. No automatic connection can be made.
Example of ringing chart set-up:
Ring to allowed
…
Ring to operator
…
Wait
0
Hang up
…
Establishing Connection
1. Run the OMEGA Lite Program SW.
2.
Press the bar button SET COMMUNICATION („tools‟ symbol) and check and
set the modem parameters:
set the COM port connected to the modem;
select the communication rate (according to the modem capacities);
select the use of PREFIX (of the master PBX, set the modem connecting tone
transmission (^ or „up arrow‟ symbol (above digit 6) according to the modem
type);
select the CO dialling type;
confirm the settings by pressing OK.
3. Press the bar button CONNECT TO PBX (three OMEGA LITE symbols in a
sequence).
4. Click (using your mouse) on the YYMM-XXXXX.PBX file, which is to be used for
remote supervision.
5. Press the CONNECT MODEM MANUAL button.
6. Select the technician responsible for remote supervision, confirm the access
password (or select a new technician by pressing the NEW button) and quit the
dialog window by clicking on OK.
7. Dial the telephone number to be used for remote supervision on the telephone
set connected to the modem, get transferred by the TRANSFER TO REMOTE
SUPERVISION (default value # # (the operator dials FLASH ## into the call)) ,
and then press the ATA button.
8. Now the connection is being established.
9. If everything is OK, the following information will be displayed gradually:
establishing connection;
connection established;