beautypg.com

Hardware installation, Software setup: which device do you have, Software setup – IOGear GWPAP1 User Manual

Page 6

background image

or

1

1. To power on the NetShair Nano,
plug into a USB port on your computer
or to a USB charging adapter of any
mobile device.

2. Download the NetShair Nano App
for your devices from their
respective app store. (App not required
for PC/MAC or other devices with full
HTML browser support).

3. Connect to the
NetShair_Nano_XXXX
Wi-Fi network.
Note: XXXX= Last 4
digits of the NetShair Nano’s MAC ID.

Hardware Installation

Do not connect the Ethernet cable until app/client setup
is complete!

USB wall charger not included

iPod / iPhone / iPad................................................... page 7
Android ...................................................................... page 13
Computer / Other ...................................................... page 19

Software Setup:

Which device do you

have?

fee for each device connected, use Router Mode to share a single
IP address between your connected devices. Using AP mode on
these networks would require each device to have a separate IP
address, likely causing an access charge for each one.