beautypg.com

IOGear GWPAP1 User Manual

Page 23

background image

23

Access Point Mode Setting
Follow the steps below to setup the NetShair Nano for AP
Mode. If you are unsure about which mode to use, see Router
Mode or AP Mode (page 5) to confirm the proper setting.

1. Make sure the “NetShair_Nano_XXXX”
Wi-Fi network is connected.
Open the Browser and enter
192.168.1.254 into the address
bar to access the web client.

2. On the Operation Mode page,
click the drop down menu and
select

AP, then click Apply Change.

3. The NetShair Nano will need
to reboot to apply the changes
made. Click

Reboot Now.

4. Once rebooted, connect an
Ethernet cable from the
modem to the NetShair Nano.

5. Connect back to NetShair_Nano_XXXX
Wi-Fi network. Open your web browser
to acess the internet.