IOGear GWPAP1 User Manual
Page 10
10
1. Make sure the NetShair_Nano_XXXX Wi-Fi Network
is connected.
2. After setting the NetShair Nano in Router Mode (see Router
Mode Setting), tap on
Advance Setting and then select
Set WAN Interface.
3. Select
PPPoE from the menu and enter
username and password.
4. Tap
OK, then Restart when
prompted. Wait approximately 60
seconds for the NetShair Nano to restart.
5. Once restarted, connect Ethernet cable
to Netshair Nano.
6. Connect back to NetShair_Nano_XXXX Wi-Fi Network.
Open your web browser to access the internet.
Router Mode: PPPoE
NetShair Nano comes preset for DHCP Mode which is the
standard mode for cable internet providers. When using NetShair
Nano with a DSL Modem please follow the steps below:
See also other documents in the category IOGear Computer Accessories:
- GUWA200 (30 pages)
- GCS1804 (56 pages)
- GCS1804 (56 pages)
- GCS634U-PLUS (22 pages)
- GCS1782 (44 pages)
- GUWH104KIT (38 pages)
- GCS1794 (40 pages)
- GUB211W6 (30 pages)
- GCS12 (34 pages)
- GCS12 (18 pages)
- GCS932UB (32 pages)
- GCS1734 (44 pages)
- GCS124U (32 pages)
- GCS82B Manual (28 pages)
- GCS1762 (45 pages)
- GCS1764 (46 pages)
- GCS602 (22 pages)
- GCS1758 (54 pages)
- GCS138KIT (33 pages)
- GCS1714 (32 pages)
- MINIVIEW GCS1774 (3 pages)
- GUIP204 v1 (56 pages)
- GCS1744 (48 pages)
- GCS661U (36 pages)
- GCS661UW6 (32 pages)
- GCS1774 (45 pages)
- GUH284R (17 pages)
- GHPB42W6 (75 pages)
- GCS82B/GCS84B (29 pages)
- GUWH204KIT (40 pages)
- GCS614A Manual (26 pages)
- MINIVIEW GCS52U (24 pages)
- GBU221P (60 pages)
- GBC201 (45 pages)
- GBGPS201 (21 pages)
- GBGPS201 (51 pages)
- GBGPS201 (118 pages)
- GBHFK211W6 (1 page)
- GBHFK231W6 (36 pages)
- GBHFK331 (36 pages)
- GBMH201 (32 pages)
- GBMA211W6 (1 page)
- GBMH221 (1 page)
- GBP201 (26 pages)
- GBP301 (40 pages)