IOGear GWPAP1 - Manual (Page 15)

15
Router Mode: DHCP (Default)
1. On the Home screen, tap Advance
Settings, then Set WAN Interface.
2. By default the NetShair Nano is set
to DHCP client. If the network
requires a username and password
to access, select PPPoE. Enter the
username and password then tap
OK.
3. Tap Restart to save settings.
4. After the NetShair Nano reboots,
connect an Ethernet cable. The
Network LED indictor will light solid
once a successful connection has
been made.
5. Connect back to NetShair_Nano_XXXX
Wi-Fi network. Open your web browser to access the internet.