IOGear GWPAP1 - Manual (Page 26)

26
Hotel provides wired Internet access
1. Do not connect the Ethernet cable until app/client setup is
complete.
2. Power on the NetShair Nano by plugging it into a powered
USB port on your Laptop or Desktop or by plugging it into a
USB charging adapter of a USB mobile device.
3. Connect your iPhone/iPad/Android Phone/Android
Tablet/Laptop to the device through Wi-Fi.
4. Follow the setup directions shown for your device type.
5. Connect the Ethernet cable in hotel to the WAN port of device.
6. If hotel charges a fee for each device connected, make sure
to set the NetShair Nano to Router Mode.
If you are setting up the NetShair Nano using a web client
(Internet Browser) and cannot get to the 192.168.1.254 page,
you may have connected the Ethernet cable before completing
device setup. If this is the case, the NetShair Nano may have
experienced an IP conflict and automatically changed the LAN
subnet to 192.168.0.254. Please enter 192.168.0.254 into your
browser and follow the setup instructions again.
Hotel Usage Explanation Note
Troubleshooting