Black Box LR1530A-EU-R3 - Manual (Page 32)

Applications
26
Basic Leased Line Configuration
routers shipped outside North America are configured to have a
default setting as a leased line router. The router will operate as a PPP
leased line bridge/router if the frame relay function is disabled. The
Leased Line router establishes PPP (Point to Point Protocol) WAN
connections to other PPP Leased Line router units or to other
vendors PPP leased line routers via direct leased line connections.
Configuration: The default configuration for North American router is to
have frame relay enabled. To run PPP leased line, frame relay must
be disabled
7
Frame Relay disable
Location: Main
Ä Configuration
Ä WAN Set up
Ä Link Set up
Ä Frame Relay
Ä disabled
The router will request confirmation of the change, enter
“yes”.
“Quick Start” PPP Leased Line Connections
The PPP Leased Line router requires only a few configuration
parameters to establish a direct connection to another PPP IP router.
Once the connection is established and is working properly, the router
should be configured with a remote site profile entry for that
vendors router.
Before the router can establish a link connection to another PPP
router, the link speed information must be defined. Refer to the
following diagram that shows an router unit and another vendors unit
connected together with a direct leased line connection.