Google Apps Directory Sync for Postini Services Administration Guide - Manual (Page 67)

70 Release 1.3.32, October 2009
Replace [filename] with the name of the XML file you created in the
Configuration Manager.
Synchronization options
The table below describes the possible arguments to the sync-cmd command. You
can also see this information by running the following:
sync-cmd -h
in the directory where the directory sync utility is installed.
Option Values
-r,--report-out Write reports to the specified output file, in
addition to writing them to the log.
-a,--apply Apply detected changes.
-V Display detailed application version
information.
-c,--config [filename] Specify the configuration to load.
Synchronization will not occur without a valid
XML file for this argument.
-d, --deletelimits Ignores any configured delete limits.
-f, --flush For support troubleshooting only (slows sync)
WARNING: This option is intended only to
resolve specific troubleshooting issues.
Improper use can cause performance
degradation. Do not use this option unless
directed by support.
-g, --groups Do not analyze groups.
Note: Do not use this option. It is intended for
other versions of the directory sync utility, and
will have no effect.
-h,--help View this information and exit.
-l,--loglevel [level] Override the default and/or configured log
level with the specified value. Valid values (in
increasing order of verbosity) are FATAL,
ERROR, WARN, INFO, DEBUG, and TRACE.
In most cases, the recommended log level is
INFO.
-s, --sharedcontacts Do not analyze shared contacts.
Note: Do not use this option. It is intended for
other versions of the directory sync utility, and
will have no effect.