JLG M600 Service Manual - Manual (Page 76)

SECTION 3 - CHASSIS & TURNTABLE
3-38 – JLG Lift – 3121813
Carrier Disassembly
1. Using a 1/4" punch, drive the Roll Pin (3G) which
holds the Planet Shaft (3E) in the Carrier (3A) down
into the Planet Shaft (3E) until it bottoms.
NOTE: Make sure that the Roll Pin has bottomed. Other-
wise, damage to the carrier could occur when the
Planet Shaft is removed.
2. Remove the Planet Shaft (3E) from the Carrier (3A).
3. Slide the Planet Gear (3F) and the two Thrust Wash-
ers (3B) out of the Carrier (3A).
4. Remove both rows of Needle Bearings (3C) and the
Spacer (3D) from the bore of the Planet Gear (3F).
5. Using a 1/4" punch, drive the Roll Pin (3G) out of the
Planet Shaft (3E).
6. Repeat Steps 1 through 5 for the remaining two
Planet Gears (3F).
3A. Carrier
3B. Thrust Washers
3C. Needle Bearings
3D. Spacer 3E. Planet Shaft
3F. Planet Gear
3G. Roll Pin
Figure 3-23. Carrier Disassembly