Section 1. specifications, 1 capacities, 2 operating specifications – JLG M600 Service Manual User Manual
Page 15: 3 generator, 4 battery charger, 5 drive/steer system, 6 tires, Section 1 - specifications, Capacities -1, Operating specifications -1
SECTION 1 - SPECIFICATIONS
3121813
– JLG Lift –
1-1
SECTION 1. SPECIFICATIONS
1.1 CAPACITIES
1.2 OPERATING SPECIFICATIONS
1.3 GENERATOR
1.4 BATTERY CHARGER
1.5 DRIVE/STEER SYSTEM
1.6 TIRES
Table 1-1. Capacities
Generator Fuel Tank
(M Models Only)
13 gallons (49.2 liters)
Hydraulic Tank
Prior to S/N 51941
S/N 51941 to Present
15 gallons (57 liters)
15.9 gal.(60.2 L)
12.4 gal. (46.9 L) to full mark
Drive Hub
0.4 gal. (1.5 liters)
Table 1-2. Operating Specifications
Maximum Work Load (Capacity)
Unrestricted:
500 lb (230 kg)
Maximum Travel Grade (Gradeability)
with Boom retracted and approximately
horizontal. Tower Boom fully lowered.
30%
Maximum Travel Grade (Side Slope) with
Boom retracted and approximately hori-
zontal. Tower Boom fully lowered.
5°
Tilt Alarm Setting (See Section 3)
ANSI, CSA
CE E/M600 & E/M600J
CE E/M 600JP
5°
4°
3°
Maximum Vertical Platform Height:
60 ft. (18.29 m)
Maximum Horizontal Platform Reach
E600
E600J
43 ft. (13.11 m)
42 ft. 9 in. (13.11 m)
Machine Width
2WD
4WD
7 ft. 11 7/16 in. (2.42 m)
7 ft. 11 3/8 in. (2.42 m)
Machine Length
E/M600
E/M600J
E/M600JP
30 ft. 11 5/16 in. (9.43 m)
30 ft. 8 15/16 in. (9.37 m)
33 ft. 3 3/4 in. (10.15 m)
Turning Radius (outside)
15 ft. 3 in. (4.65 m)
Turning Radius (inside)
4 ft. (1.23 m)
Maximum Tire Load:
7700 lbs. (3500 kg)
Maximum Ground Bearing Pressure
E600J/M600J
E600JP/M600JP
52 psi (3.7 kg/cm
2)
51 psi (3.6 kg/cm
2)
Maximum Drive Speed:
3.0 mph (1.3 m/s)
Electrical System Voltage
48 volts
Maximum Hydraulic System Pressure
3200 psi (221 Bar)
Maximum Wind Speed
28 mph (12.5 m/s)
Maximum Manual Force
400N
Gross Machine Weight (Platform Empty)
E600J/M600J
E600JP/M600JP
16,300 lb. (7,393 kg)
16,800 lb. (7,620 kg)
Table 1-3. Generator
Alternator Output
58 volts @ 45 Amps
RPM’s under max. load
3100
Start Battery
12 volts
Engine Oil
10W30 (Refer to Engine Manual)
Dynamo
12 volt, 15 amp DC
Dynamo Output Fuse
20 amps DC
Control Fuse
15 amps DC
Table 1-4. Battery Charger
AC Input
120V - 240V Auto Seeking
AC Draw
17 amps at start of charging
DC Output
48 volts, 23 amps
Table 1-5. Drive System
Drive Motor
48 VDC, 12.5 H.P. @ 3200 rpm. con-
tinuous, rotation - reversible
Drive Brake
spring-applied, hydraulically released
Table 1-6. Tires
Size
Type
Pressure
36/14 LL-22.5
pneumatic
55 psi (4.0 Bar)
36/14 LL-22.5
foam filled
N/A
Table 1-2. Operating Specifications